HYDRAULIC PRESS BRAKE
Standard:
- NC controller Estun E21 (X,Y)
- Bosch Rexroth hydraulics
- Schneider electric
- Siemens motor
- Sunny (USA) gear pump
- Ball spindles
- Front support arms (2 pieces)
- Segmented punch (H=150mm) - Amada clamping system
- Bottom tool
- Safety equipment in accordance with following standards:
-EN12622:2009+A1:2013
-EN ISO 12100:2010
-EN 60204-1:2006+A1:2009
Main characteristics of controller Estun E21:
- Controls two axes : X (backgauge) and Y (slider)
- Max.No of saved programs = 40
- Max.No of steps in one program = 25
- Max.speed of backgauge (X-axis) = 40mm/s
- DX - axis
- Accuracy = 0.15mm
- Estun enkoders
General characteristics:
-
mechanical system to run with a torsion bar,
-
mechanical breaking system
-
possibility of continuous adjustment of pressure and stopping points of the pressing position,
-
possibility of adjusting the backgauge and gap between tools with a reading at the appropriate values of these counters,
-
three types of impact: singles, continuing and stepping,
-
buttons to stop in an emergency,
-
protection system connected to an electrical closet and a protective fence
Hydraulics:
- hydraulic valves brand Bosch (Germany)
- seals brand NOK (Japan)
Electric:
- electric components brand Schneider ili Siemens
Controller:
- ESTUN (China) - NC press brake
- CYBELEC (Switzerland) - NC and CNC press brake
- DELEM (Nederland) - CNC press brake
Any modification on the press to your request is possible.
Technical characteristic of different models of press brake: SEE HERE
CNC presses with servo electro-hydraulic steering without modifications can also be supplied in the following models: SEE HERE
NOTE: if you do not know the required force, and you know the thickness and width of the sheet SEE HERE
